Question for the community,
I'm building a new FreeNAS RAID with brand new HDD's. I would like to make sure that all of the drives are going to function properly before moving any data onto them.
Is there some type of program that you would suggest that I could run to perform a stress test on the RAID array before hand? Is there a test that can be run directly from FreeNAS? If so, what would the parameters be to get the best out of it?
I had previously asked this same question;...
Checking new HDD's in RAID
I'm building a new FreeNAS RAID with brand new HDD's. I would like to make sure that all of the drives are going to function properly before moving any data onto them.
Is there some type of program that you would suggest that I could run to perform a stress test on the RAID array before hand? Is there a test that can be run directly from FreeNAS? If so, what would the parameters be to get the best out of it?
I had previously asked this same question;...
Checking new HDD's in RAID