Hello,
Not sure if this is a right place to ask a Windows question here...![:)]( "Smile :)")
I have purchased a LSI 9210 card from EBay, flash it to IT mode with P19 firmware. I use it as a JBOD/HBA fashion of 4 SATA drives in windows 10, no software raid.
So the question is, for native SATA drives, I can set the ports in windows to be hot-plugged, so that I can do a "Eject (safely remove)" for these drivers.
In device manager, if I right click on those drives, there is a "Removal policy" under the...
Eject (safely remove) drive from Windows [SAS2008][LSI9210][Windows10]
Not sure if this is a right place to ask a Windows question here...
I have purchased a LSI 9210 card from EBay, flash it to IT mode with P19 firmware. I use it as a JBOD/HBA fashion of 4 SATA drives in windows 10, no software raid.
So the question is, for native SATA drives, I can set the ports in windows to be hot-plugged, so that I can do a "Eject (safely remove)" for these drivers.
In device manager, if I right click on those drives, there is a "Removal policy" under the...
Eject (safely remove) drive from Windows [SAS2008][LSI9210][Windows10]